After thoroughly vacuuming under the aft seat pans, I installed the forward seat pans and threw a few screws in to keep them in place. I figured now was as good a time as any to fit the stick boots so that I could install the velcro around the stick opening.
I only have a little work left to do in the tail, so I put the lower baggage wall in place to that I could fit the interior.
Part of the flange needed to be trimmed to clear the wiring and tubing that I installed near the front edge of this rib for some reason. There was no good reason I couldn’t have installed this near the back of the rib.
I then put the experimental sticker on the upper baggage wall and installed it. I’ll generally have the upholstery cover over this, but I installed it anyway since I’ll likely fly without most of the interior during testing.