Finished Fuselage Wiring and Fabricated Flap Pushrods

I hooked up the canopy switch wires and verified the annunciator light illuminated appropriately.

I attached the ground wire to one of the canopy latch pivot block mounting bolts on the back side of the bulkhead.

I also installed a connector and some zip-tie bases in the roll bar support channel and hooked up the cabin light.

Finally, in preparation for mounting the wings this Friday, I fabricated the flap pushrods.  I cut the tubes from some 5/16″ stock with 0.058″ wall thickness and then drilled/tapped the ends for the 1/4″-28 bearings.

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.