I got an order from Avery Tools today with some cable clamps that can be attached with screws or pop rivets. I’m using these in lieu of the adhesive cable clamps in areas where the detachment of the clamp could interfere with the controls. I’ll likely end up installing these in any spot where it’s fine to drill a hole through the structure. I really wish I knew about these back when I installed the conduit under the seats and baggage floors instead of the adhesive cable clamps.
I installed several of these along the forward center tunnel to keep the flap motor and flap position sensor wires away from the elevator pushrod. Jeez, do I need to vacuum in here or what?
I also installed a set of these up the center baggage wall support to secure the network cable to the ADAHRS.
Finally, I slipped some sleeving over the wires to the aileron trim servo and installed a five position molex connector I picked up at Fry’s this morning.
