I installed the SkyView screens and radio stack and fired up the panel to make sure everything was working properly.
Next, I installed the control cables in the bracket and attached that to the bottom of the instrument panel.
I didn’t get a shot of this last night, but here’s the back of the Gemini PFD. I still need to install a DB-9 connector shell, but this shot shows the pitot and static connections. The green tubing is the pitot and the white tubing is the static. This has to tee to go up to the alt static switch.
Here’s the alt static switch. This opens the static tubing up to cabin pressure.
To wrap up the panel, I put switch boots on most of the switches. All of these are marked red because switching any of them in flight could be critical.
All light switches are blue. Here are the exterior lights.
The interior lights both have dimmers. Here are the controls for the cabin lights which are mounted in the roll bar support.
Here are the glare shield lights.
The fuel pump and flaps have yellow boots because operating them should be done with caution.
Here are the completed seat heater controls. The cabin heat control is just to the right.
