Finished Interior Lighting

I decided to finish up the interior lights tonight.  The final light is a small stick-on LED light strip that will cast a dim glow in the footwell so that I can see where my feet are and see the fuel selector.  I’m going to install it to the bottom of the control cable support bracket, but I need to paint it first, so it’s just held on with a piece of masking tape right now.  I put a 39kΩ resistor inline with the lights to dim them down pretty far.  The light should be dim enough that it’s not a distraction when flying at night.

With all of the wiring done behind the panel, I started zip-tying the bundles.

I also installed a connector shell over the panel ground block wires.  I *think* all of the wiring behind the firewall is complete now except for the final hookups to the TruTrak Gemini and the elevator trim servo.

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.