I fit the crankcase breather tube this afternoon. The tube attaches to a fitting at the top of the accessory case with a piece of rubber tubing.
The tubing attaches to the firewall with an adel clamp near the heater box. I had to drill out one of the rivets and rivet on a nutplate. This adel clamp is the wrong size, but I don’t have any of the correct size.
The bottom of the tube is cut so that it’s parallel to one of the exhaust pipes. I’m not sure if this is too close or not, but I’ll do the final adjustment when I install the exhaust hangers. This is installed close to the exhaust pipe so that any residue that is vented through the breather will be burned when it hits the exhaust pipe.
